Preheat And Interpass Temperature: Welding Thick Plate Properly

Nov 20, 2026

Leave a message

Thick steel plates and high-strength grades are less forgiving than thin sheet. Weld them cold, or let the joint overheat between passes, and you can create hard, brittle zones that crack later. Preheat and interpass temperature control is how fabricators prevent that.

1. Why preheat

Preheating slows the cooling rate after welding. Slow cooling gives the weld and heat-affected zone time to transform into a tougher microstructure, and lets hydrogen escape. Fast cooling in thick plate can produce hard, crack-prone zones.

2. Why interpass temperature matters

Between passes, heat accumulates. If the joint gets too hot, the steel can lose strength and toughness, and distortion increases. Maximum interpass temperature limits how hot the joint is allowed to get.

3. What determines the numbers

Steel grade and thickness.

Welding process and consumable.

Ambient temperature and wind.

Joint restraint and geometry.

The procedure should state minimum preheat and maximum interpass temperature for each case - not a single number for everything.

4. How it is controlled on the shop floor

Heating with torches or electrical blankets.

Measuring temperature at a defined distance from the joint.

Checking before welding and between passes.

Protecting the joint from wind and rain.

Recording the measurements.

5. The risks of ignoring it

Hydrogen cracking, often delayed by hours or days.

Brittle heat-affected zones.

Excessive distortion.

Failed inspection and expensive repairs.

6. What to ask

What preheat and interpass limits apply to my thickest joints?

How is temperature measured and recorded?

Are welds inspected after cooling, not immediately?

What happens in cold or windy weather?

In short: thick-plate welding is a thermal process, not just an electrical one. Preheat, cap the interpass temperature, measure and record - and the joint will be tough instead of brittle.

Contact us and send us your requirements - we will get back to you as soon as possible with a quotation.